GE WR57X10032 Water Valve for Refrigerator

• WR57X10032
• 1 year manufacturer warranty
• Genuine GE factory part
• Water Valve

After researching causes for not getting water through the door I had ruled out the line being frozen.My tests showed that the relay on this valve was getting energized yet there was barely a trickle of water coming out so I assumed the valve needed replacing.A new valve did not solve the problem.The root cause was the fitting that holds the water filter.One of the tubes leading into the fitting was plugged, preventing filtered water from reaching the valve I had tested.

Buy GE WR57X10032 Water Valve for Refrigerator Now

Ordered, installed product within 10 minutes.Easy, no hassle.Great product, cheap on Amazon, and fast delivery!

Yet, the new product was not was I needed.The water dispenser was not dispersing water. I replaced the water valve as attempts to the easy route.Still had the problem!

Similar to other posting, my issue was water line inside the door freezes. Remove the kick panel below the refrigerator and freezer doors and look for the water line disconnect just behind the front panel near the freezer door hinge. Disconnect the water line and shut the door. Press the water dispenser and see if water comes out of the water line at the bottom where you'd disconnected the water line. If water comes out, you'll need to just turn the refrigerator off and leave the door open for about 45 minutes and that will allow the door to heat up enough that when you connect the water line to the door again, it should start to dispense water again. Using a hair dryer to warm up the door is also very useful.

Read Best Reviews of GE WR57X10032 Water Valve for Refrigerator Here

Good part at a good price. it was a over all go.od experience.I'm very happy with the part and how it went back together.

Want GE WR57X10032 Water Valve for Refrigerator Discount?

Perfect fit and was installed within 5 minutes.Great replacement!!!!!!Would highly recommend this product to anyone having water valve problem.Now if only I could keep my water line from freezing, I'd be really happy!

Save 63% Off

This is a drect OEM replacement part for my old dual outlet water valve. It's easy to install.Just remove the back cover, I used nutdriver screwdrivers.Remove the single screw that holds the old bracket on.Swap the outlet lines, then swap the connectors.Mount the new valve, then remove the inlet valve from the old one and screw it onto the new one.

Leave the back cover off for a while and wait for a couple of icemaker cycles and use the water through the door dispenser a few times.Check for leaks.If no leaks, then install the back cover using the 4 screws and you're done!

Better yet watch how this guy does it